top of page

How to

First set the Cover to be adjusted to your Shoe Size
When you first take the covers out of the box you will need to adjust the elastic to match your shoe size. (Once adjusted, you will only need to do this once, the pull toggle will hold the correct tension to your shoe after it is adjusted the first time.)
1. Step into the cover.
2. Find the pull toggle located at the back right of each cover at the heel.

3. Pull the elastic and pull toggle at the same time untill the elastic draws up tight against your shoe.
4. Feel around your shoe and make sure the elastic is tight to your shoe.
5. Make sure the cover will still open up after you tighten the elastic.

(If you over tighten the elastic, the cover may not open up easily.)

(if you don't tighten the cover up enough it could fall of while walking.) 

6 Steps of Using the Cover
ALWAYS HOLD BOTH ENDS OF THE SAME SPRING ALLOWING YOU TO OPEN EACH SPRING SEPARATELY, BOTH SIDES OF THE SPRING WILL OPEN AT THE SAME TIME. 
1.  Set the Center Spring

 

To set the center spring (the longest of the three springs) hold both ends of the strip at the same time and straighten the spring strip out.

2. Set the Heel Spring​

 

To set the Heel spring (the shortest of the three springs) hold both ends of the strip at the same time and straighten the spring strip out.

3. Set the Toe Spring​

 

To set the toe spring (the middle size of the three springs) hold both ends of the strip at the same time and straighten the spring strip out.

4. Lay Both Covers Flat on the Ground​

 

Find an even surface in a clean area then lay the covers flat with the logo facing up. The covers should face forward leaving the narrow end closest to you.

5. Step-in the Cover​

 

It is easiest to step in the covers one foot at a time, for the best balance. When stepping in the cover keep your shoe placed inside the white outline that is shaped like a shoe.

6. Take the Cover off​

 

Pull the cover off by holding the heel of the cover and sliding it off your shoe.

bottom of page